Hello,
I assume RUG means RepRap User Group?
is there any local club around here? I am looking for help with my H-bot style 3D printer
[www.thingiverse.com]
another builder of same printer said he did not have to modify the Repetier firmware provided by the designer.
I am using Arduino Mega 2560 with RAMPS 1.4 board, the stepper motor test works, but I need help with the Firmware, I tried Marlin and Repetier.
the stepper motor not moving smooth or too fast and too far. when I tell it to Z move 1mm in control panel, it jumps few inches, or some times flies to the end.
I need guidance of what I need to do next. printer is built, stepper motor test passed, firmware is loaded, ok so now what?
This site speaks of sending codes, but how or from where?
[www.repetier.com]
I assume RUG means RepRap User Group?
is there any local club around here? I am looking for help with my H-bot style 3D printer
[www.thingiverse.com]
another builder of same printer said he did not have to modify the Repetier firmware provided by the designer.
I am using Arduino Mega 2560 with RAMPS 1.4 board, the stepper motor test works, but I need help with the Firmware, I tried Marlin and Repetier.
the stepper motor not moving smooth or too fast and too far. when I tell it to Z move 1mm in control panel, it jumps few inches, or some times flies to the end.
I need guidance of what I need to do next. printer is built, stepper motor test passed, firmware is loaded, ok so now what?
This site speaks of sending codes, but how or from where?
[www.repetier.com]